6 min read · Updated November 8, 2026
How to Clean and Dry Running Shoes Before Your Next Run
Clean and dry wet or muddy running shoes with practical hand-washing steps, material checks, and a sensible plan when your next training run or race is close.
Wet or muddy running shoes usually need gentle hand-cleaning and drying at room temperature with good airflow. For runners facing another training session or race soon, the best approach is to remove loose dirt, clean only what needs cleaning, and allow time to dry; a hot dryer is a poor shortcut. Check your shoe’s own care instructions first, because materials and cleaning recommendations differ.
Can running shoes go in the washing machine?
Hand-cleaning is the sensible default unless the manufacturer explicitly permits machine washing for your model. Brooks advises against both washing machines and dryers, explaining that aggressive washing can damage shoe materials and heat can affect adhesives. Its recommended approach uses a soft brush or cloth, gentle cleaning, and air drying. citeturn348488search0
That answer is less convenient than pressing a button, but it gives you control over the parts that actually need attention. A muddy outsole does not require saturating the entire upper. A dusty upper does not necessarily require detergent.
Start by identifying the job: removing loose dirt, washing away stubborn grime, or drying a shoe that is already clean but soaked. Treating those as separate tasks prevents an unnecessary full wash the evening before a run.
Care labels outrank a general cleaning recipe. New Balance’s shoe-care guidance recommends a mild, dye-free detergent and a brush for athletic shoes, while identifying suede and leather as materials that need suitable specialist cleaners. It also advises testing a cleaning product before broader use. citeturn348488search3
If you are unsure what the upper contains, look up the exact model. Similar-looking shoes can need different treatment.
Decide how much cleaning the shoes need
Use the smallest cleaning job that solves the problem. The following table is an editorial triage guide based on the manufacturers’ care instructions linked below; it is not a claim that every material tolerates the same treatment.
| What you find | Recommended first move | What to leave until later |
|---|---|---|
| Dry dust or loose dirt | Brush it away gently | A full wash for appearance alone |
| Dried mud around the outsole | Brush off loose material, then clean stubborn areas carefully | Soaking the whole shoe |
| Wet shoes with little visible dirt | Remove removable components and begin air drying | Adding water or cleaner unnecessarily |
| Stubborn marks on a textile upper | Check the care instructions, spot-test, then clean gently | Repeated hard scrubbing to chase a cosmetic stain |
| Suede, leather, or unfamiliar materials | Follow the model’s material-specific instructions | Applying a generic detergent mixture |
ASICS recommends removing dried mud with a soft brush and treating the upper gently with a damp sponge. That is a useful distinction: the robust-looking dirt on the bottom and the fabric around your foot do not need identical handling. citeturn348488search2
Set a reasonable finish line for the cleaning itself. Shoes can be ready for another run without looking new. A faint stain is a different problem from mud still trapped around the tread or a damp insole.
How to hand-clean running shoes
1. Remove the laces and removable insoles
Take out the laces and any insoles designed to be removed. Do not pull out a component that appears fixed in place. Opening the shoe makes it easier to reach dirty areas and inspect the interior.
Nike’s hand-washing instructions treat the laces, soles, and uppers separately and recommend allowing cleaned insoles to dry before replacing them. Use that separation to avoid repeatedly wetting a part you have already finished cleaning. citeturn348488search1
Lay the components together somewhere you can leave them undisturbed. If you are cleaning several pairs, keep each pair’s insoles beside the correct shoes.
2. Brush off loose dirt before adding water
Use a soft shoe brush or another gentle brush suitable for the material. Remove loose dirt from the upper and outsole without forcing grit across delicate fabric.
Work patiently around tread grooves. If dirt does not come away easily, move to gentle spot-cleaning rather than increasing the force. This is a cleaning task, not a test of how much scrubbing the mesh can withstand.
Do this stage over a surface you can clean afterward. It is easier to collect loose dirt than to spread it through the place where the shoes will dry.
3. Use a mild cleaner only where needed
Prepare the cleaner your manufacturer recommends. Avoid assuming that a stronger mixture will produce a better result.
For example, ASICS recommends a mild detergent solution for appropriate shoe components and warns against bleach and household cleaning products. Its guidance also cautions against hard scrubbing that could damage the upper. Follow those limits rather than improvising a stain-removal experiment on your race shoes. Read the ASICS cleaning steps.
Spot-test first where your manufacturer advises it. Clean gently with a suitable cloth, sponge, or brush, then remove the cleaning residue as directed. Keep checking whether you have already achieved the practical goal. More cleaning is not automatically better cleaning.
4. Clean the laces and insoles separately
Laces are easier to work through when they are out of the shoe. Follow the maker’s instructions for washing and removing residue, then set them aside to dry.
Treat insoles according to their own instructions, especially if you use an aftermarket insert or orthotic. The shoe brand’s advice may not cover an accessory made by someone else.
Before reassembling the shoes, inspect every component. Putting a damp insole inside an otherwise dry shoe defeats the point of checking only the outside.
How do you dry wet running shoes without heat?
Use room-temperature airflow and give moisture somewhere to go. Nike’s shoe-drying guidance describes using a fan or absorbent newspaper, recommends removing insoles, and advises against drying shoes in an oven or near a heater. It also warns that dryer heat can damage shoes. citeturn492933search0
Choose a place where air can reach the shoes, with the opening accessible. If you use newspaper, replace it when it becomes wet. If you use a fan, position the shoes securely so air reaches the openings; do not hang them from a fan or improvise an unstable arrangement.
Keep the shoes and removable components apart until dry. You are trying to dry the interior as well as the fabric you can see.
There is no useful universal promise that a soaked pair will be ready in a certain number of hours. New Balance notes that drying time depends on how wet the shoes are. Its guidance recommends air drying and avoiding direct heat. Check its cleaning and care advice.
Plan around the shoes’ actual condition. A suggested drying time is a scheduling estimate, not permission to stop checking.
Check inside before calling the job finished
Feel the removable insole, the fabric beneath it, and the padding around the heel and tongue. If something still feels damp, leave the components apart and continue drying.
Make that check before packing a race bag. Finding a damp pair while you still have options is useful; discovering it beside the starting area is merely information.
What if your next run or race is tomorrow?
Prioritize a familiar, usable pair over a cosmetic cleanup. If the shoes are only dusty, consider brushing them and postponing a full wash. If they are soaked, start drying them promptly and assess your backup before bedtime.
Here is a hypothetical decision example, not a guaranteed drying schedule:
A runner returns from a muddy Saturday session and has a Sunday road race. The outsole is dirty, the upper is splashed, and the removable insoles are wet. The practical response is to remove loose mud, clean the necessary areas according to the shoe instructions, and dry the separated components with airflow. The runner also checks a familiar backup pair that evening.
On Sunday, the original pair is still damp inside. The decision should now be about which familiar pair is suitable for that course and feels right during a brief check. Another frantic cleaning attempt will not improve the available choices.
Do not use this situation as a reason to debut unfamiliar shoes. RaceThere’s guide to testing new running shoes before race day can help you assess a replacement before you need it urgently.
A second pair can make scheduling easier, but one wet weekend does not create an obligation to buy shoes. If this problem keeps interrupting training, consider whether a useful running-shoe rotation fits your routine and budget.
What should you avoid when cleaning race shoes?
Avoid turning a maintenance job into an experiment. Manufacturer guidance gives you a narrower, more dependable starting point than a collection of household cleaning tricks.
Be particularly cautious about:
- Heat used to rush drying, including dryers, ovens, and heaters.
- Strong chemicals or cleaners intended for other household surfaces.
- Hard scrubbing on mesh or other delicate upper materials.
- Cleaning leather or suede as though it were ordinary textile mesh.
- Washing a pair immediately before you need it without a drying plan.
The first four points follow the manufacturer instructions above. The last is a planning recommendation: leave yourself room to discover that a shoe needs more drying time or a different cleaning method.
If a shoe looks damaged after cleaning, do not assume that being clean makes it ready to race. Pause and assess the damage or ask the manufacturer about the affected component. Cleaning and checking condition belong together.
Make the next wet run easier to manage
Keep a soft brush, a suitable cloth, and your model’s care instructions easy to find. Decide where shoes can air dry before the next soaked pair comes through the door.
After a wet outing, inspect the shoes before putting them away. Separate drying from cosmetic cleaning: deal with moisture and material care first, then decide whether the remaining marks justify more work.
When you compare races on RaceThere, check the organizer’s course and surface information so you can prepare an appropriate, familiar pair. The best shoe-care routine leaves you with fewer last-minute decisions before the start.
Find your next race on RaceThere, and give your shoes time to be ready for it.